AFCO HWwasherClick image to enlargeAutomatic Feed Co.’s coil-fed high-pressure hot water washers eliminate oil and contamination on aluminum and various metals that can cause visible part defects during the stamping process. 

These washers strip away any particles above 20 to 40 microns (.000788” to .001576”) and greater to improve surface quality.

The hot water washers use a reverse osmosis system to ensure water quality for the washing process. They can handle coil materials up to 84” in width and achieve line speed of 300 fpm. 

The systems include entry and exist mist containment, which prevents moisture and steam from escaping into the factory. A spray chamber contains the spray headers and nozzles, directing water onto the material. An air knife system uses low pressure, high volume air to blow the water off the strip, resulting in dry material exiting the washer.

The system entry and exit use opposing rolls to support and drive the material through the machine. All peripheral washing equipment for process water storage, heating, pumping, filtering, oil/water separation and moisture containment are included. 

These hot water systems are typically paired with an electrostatic re-oiling system with a metering pump to provide uniform film thickness at line speeds. Hydraulic span table sections can be included with the washer for use when the oiler is rolled out of line.

The hot water washers feature an electrical control system and control hardware. Automatic Feed has designed, manufactured and installed over 40 of these systems to date.

www.automaticfeed.com

Emuge industry first: general purpose tap

Calling it an industry first, Emuge's MultiTap is a high performance tap designed for threading a range of materials including carbon steel, steel alloys, stainless steel, aluminum, cast iron, copper, brass and bronze.

Elliott Matsuura Canada Inc.

Based in Oakville, Ontario, Elliott Matsuura Canada Inc. has been supplying and supporting quality machine tools to the Canadian metal cutting industry since 1950. Elliott carries a full range of metalworking machinery,

Kennametal: Tapping into the wind turbine market

New high performance taps for large diameter tapping from Kennametal feature a wear-resistant powder metal substrate and proprietary top layers and coatings, designed wind turbine component machining of hubs, rings and gearbox housings.

Multi-Tasking: Is it Right for Your Shop?

For manufacturers looking to achieve that competitive edge, you can do no better than a multi-tasking machine. They eliminate the need for separate milling and turning machines, multiple set-ups and, most importantly, they improve productivity.

The Rules of X-Ray Micro CT (and When to Break Them)

Offer the term “metrology equipment” to a group of industrial or manufacturing engineers in a word-association test and it's highly likely CMM (coordinate measuring machine) would be the response.

Stay In Touch

twitter facebook linkedIn