CANADA'S LEADING INFORMATION SOURCE FOR THE METALWORKING INDUSTRY

LATEST MAGAZINE

CANADA'S LEADING INFORMATION SOURCE FOR THE METALWORKING INDUSTRY

CANADA'S LEADING INFORMATION SOURCE FOR THE METALWORKING INDUSTRY

Servo electric pump for waterjet cutting

Share This Post

The Quantum NXT electric servo pump from Techni Waterjet incorporates a servo motor directly enveloping a high load, precision ball screw. 

The ball screw directly houses the ceramic plungers, which reciprocate back and forth to create the pumping action, in much the same way as a hydraulic cylinder works on an intensifier pump.

The infinite control of the servo motor and precision of the ball screw, enable extremely accurate control over the output pressure and volume of the water displaced, and eliminates pressure spikes when deadheading. This infinite control gives an operator the ability to program virtually any pressure and flow rate from zero to full capacity, while only using the power displaced at the cutting head.

The Quantum NXT is breakthrough technology for the waterjet industry, representing the greatest change in the Industry for more than 25 years says Darren Reukers, Managing Director of Techni Waterjet. “We have breakthrough technology because it does not rely on an inefficient hydraulic system, but instead uses the servo motor to directly drive the plungers, resulting in significantly less power to operate, up to 60 per cent in most cases. The water consumption is also greatly reduced as the high efficiency servo motor requires minimal cooling. These two factors, as well as the reduced size, noise, and oil requirements, make the Quantum NXT an environmentally friendly solution.”

Techni Waterjet

Share This Post


Recent Articles



WordPress Ads
Wordpress Social Share Plugin powered by Ultimatelysocial
error

Enjoy this post? Share with your network